Loading...
 
Skip to main content

System Workbench for STM32

Forum List Topic List

Forums » System Workbench for STM32 » System Workbench for STM32 installation and configuration on Linux
 
Thread actions
Print this page
  • Print all pages

    • System Workbench for STM32 installation and configuration on Linux

    Posted by bluenow on 2016-10-07 18:23

    Hi,
    I had installed the System Workbench for STM32 on 64bit Ubuntu 16.04.1 LTS by run the installer.
    It semms every thing goes fine at first, and I was able to import a project which is generated from STM32CubeMx.
    The project built and an elf file was generated, but when I try to download it to my STM32F0308 Discovery board, the System Workbench for STM32 comes to be very slow responding. After long waiting, there is a error message saying that something in "debug configuration" wasn't been set correctly. But the problem then I have is, whenever I try to look the "project properties", the System Workbench for STM32 comes to be very slow responding.
    I'm not sure how I can fix this? Any log file I can looking?
    Thanks.
    -BNow

    Reads: 9372
    Posted by bluenow on 2016-10-07 19:31

    Here is an error message I had seen when System Workbench for STM32 stop responding.

    Gtk:ERROR:/build/gtk+3.0-6ZPWga/gtk+3.0-3.18.9/./gtk/a11y/gtkaccessibility.c:564:gail_focus_notify_when_idle: code should not be reached

         Posted by bluenow on 2016-10-07 21:15

    searching around, I saw there someone has mentioned that "SWT_GTK3=0 /yourpath/eclipse &"
    to fix one of GTK related issue.

    I tried it and it fix my problem.
    Now I can change the project properties and run debugging my STM32F0Discovery board through OpenOCD/STLinkv2 .

    Hope this will help someone.

         Posted by bluenow on 2016-10-07 22:27

    OK. This seems be the better solution.

    specify the GTK version 2 instead of 3, in eclipse.ini

    So, add below lines into /yourpath/eclipse.ini

    --launcher.GTK_version
    2

    , before Vmargs