System Workbench for STM32

I am glad you got a Blinky program to work!!!

I think I know what you mean all of this stuff is a bit confusing to me as well, but in time I will figure it out.

Here is another Blinky program that is written a little differently but it flashes both the Red and Green LEDS on PG13 & PG14.

It took me a while to figure this one out as well.

In this version I followed the same steps only I just copy pasted the file as I had found it into the created blank Blinky project and it didn't work and it should have.

It wasn't until I commented out lines 2, 5 and 6 that I got it to compile correctly.

Again the value for "i" (2500000) controls the Binky rate in line 25.

Here is the "main.c" file as I have it working.

I hope this helps!! 😉

jer 😊