Loading...
 
Skip to main content

System Workbench for STM32

Forum List Topic List

Forums » System Workbench for STM32 » Can target with CMSIS-DAP interface be programmed/debugged?
 
Thread actions
Print this page
  • Print all pages

    • Can target with CMSIS-DAP interface be programmed/debugged?

    Posted by modtronix on 2016-02-13 02:08

    Hello

    Does anyone know if "System Workbench for STM32" can program and debug STM32 chips with the CMSIS-DAP interface?

    Like the Seeed Arch Max:
    https://developer.mbed.org/platforms/Seeed-Arch-Max/

    This board implements the CMSIS-DAP interface for firmware and programming:
    https://github.com/xiongyihui/CMSIS-DAP/tree/master/shared

    On
    this link it lists cmsis-dap, but I am no sure if this support is included with "System Workbench for STM32"?

    Reads: 12395
    Posted by tarek bouchkati on 2016-02-15 10:40 Tunisia

    Hello David,

    Yes this is possible using SystemWorkbench,

    You just need to create a custom cfg file with the following content :

    arch_max.cfg
    Copy to clipboard
    source [find interface/cmsis-dap.cfg]
source [find target/stm32f4x.cfg]


    Then you need to create a debug configuration that uses this custom script : (Debugger TAB > Use local script > point to 'arch_max.cfg')

    Regards,
    Tarek


         Posted by modtronix on 2016-02-15 12:07

    Hi, thanks for reply! We are busy creating a CMSIS-DAP interface for our NZ32-SC151 board:
    modtronix.com/nz32-sc151

    It uses the STM32L151RC chip. Will we have to contact the creators of System Workbench to add support for our board and STM32L151RC chip? Or, is it already supported?

    Posted by tarek bouchkati on 2016-02-15 12:45 Tunisia

    The good news is that STM32L151RC is already supported 😊

    Image

    And this is quite enough to use System Workbench to develop for you board.

    But I do not know if System Workbench creators have any intension to support any other board not provided by ST.