Loading...
 
Skip to main content

System Workbench for STM32

Forum List Topic List

Forums » System Workbench for STM32 » Cannot set up debugging at all » Cannot set up debugging at all
You are viewing a reply to Cannot set up debugging at all
 
Thread actions
Print this page
  • Print all pages

    • Cannot set up debugging at all

    Posted by tang on 2016-06-28 10:07
    In your "Ac6 STM32 Debugging" profile, go to the "Debugger" tab, then in the OpenOCD setup, try to select "Manual Spec" and choose the ST-Link/V2 as device and the SWD as interface.
    Reads: 3211