Loading...
 
Skip to main content

System Workbench for STM32

Forum List Topic List

 
Thread actions
Print this page
  • Print all pages

    • C project Wizard - "Finish" button inactive

    Posted by cartu38 on 2017-09-28 15:15 France

    Hello,

    Thanks for sharing.

    For sure such is quite weird.
    Fact number 1 is once project name is set wizard is allowing you to push Next button to move thru wizard' pages : such is ok on your side according shared snapshots.
    Fact number 2 is as soon as you are selecting a target (board), finish button should be enabled allowing you to launch project creation without taking care about firmware options page : sounds such step is already KO on your side ...

    Definitively not convinced about, but just in case, if ok to you, could you update your current System Workbench for STM32 ?. 28-08-2017 release is not latest one.

    Thanks to share back outcomes.
    Br.

    Reads: 3307
    Posted by Jurist88 on 2017-09-29 10:38

    Hello,
    I've done the update (haven't cleaned the registry files, though - just deleted old and installed new one).
    Result - I can get to active Finish button much more frequently (60-80% of attempts)

    I'll try later to test it more thoroughly, probably with screen video. (Now always when I tried to capture screen video, project creation always worked 😀 - almost Heisenbug)


         Posted by Jurist88 on 2017-10-05 10:06

    Hi,
    Today I tried to create project again. As result, ot failed; I managed to get the screen video too.
    please, see the link : https://vimeo.com/236881015