Loading...
 
Skip to main content

System Workbench for STM32

Forum List Topic List

 
Thread actions
Print this page
  • Print all pages

    • ac6 cannot debug/program stm32F411RE after update .... yet again.

    Posted by tang on 2019-05-10 10:33

    Hi,

    I've renamed the file. It was generated in the project directory (as "Project_Name Debug.cfg")

    If you need to use an old config file "openocd/scripts/st_board/nucleo_f411re.cfg", I think you have to add "-s PATH_TO_OPENOCD/openocd/scripts" (PATH_TO_OPENOCD to replace with the actual path) in the OpenOCD Options to indicate where to find the "target/stm32f4x_stlink.cfg" file.

    Regards,

    Kevin.
    (Ac6)

    Reads: 2033