Loading...
 
Skip to main content

System Workbench for STM32

Forum List Topic List

Forums » System Workbench for STM32 » How to modify mcu to an existing cube Mx file (*.ioc)
 
Thread actions
Print this page
  • Print all pages

    • How to modify mcu to an existing cube Mx file (*.ioc)

    Posted by asierdo on 2019-06-12 19:02

    Hi,

    I have a project generated from project1.ioc cubemx file. Project1 uses STM32L031F4 (16Kb).

    Now in project2 I want to use same configuration used in project1 but with other mcu (STM32L031F6) with 32kB.

    My question is... how could I modify project1.ioc to set STM32L031F6. Must I generate a new project from zero to generate project2.ioc with 32Kb part ?

    Thank you,
    Asier.

    Reads: 13057
    Posted by tang on 2019-06-13 12:07

    Hi Asier,

    I think it is better to generate a new project from CubeMX. I don't think you can change the MCU from the ioc file because there are compilation flags / or code that might change.

    Regards,
    Kevin
    (ac6)