Loading...
 
Skip to main content

System Workbench for STM32

Forum List Topic List

Forums » System Workbench for STM32 » How debug custom board
 
Thread actions
Print this page
  • Print all pages

    • How debug custom board

    Posted by ryngwel on 2018-01-19 21:26

    Hello ! I can not make it below correctly.
    I have discovery board with st link integrated and system workbench ac6. In this case everything is OK !
    Problem is to debug custom board with STM32F030K6T6. Programming in St-link utility and viewing variables via STM Studio works perfectly so the pins connections are good in my opinion.
    Unfortunately programming/debuging in workbench ac6 is not corect (for discovery board is OK!). I can't find any resolve of my problem, can you suggest something?

    I am using stm cubemx to creating projects.

    Reads: 8370
    Posted by LaurentL on 2018-01-23 17:41

    Hello,

    Did you connect the Reset line from STLink to your F030 mcu ?
    If not, you should choose the "Software system reset" mode in debug configuration (debugger tab).

    If still not working, can you show the openocd log message ?

    Rgds,
    Laurent