Loading...
 
Skip to main content

System Workbench for STM32

Forum List Topic List

 
Thread actions
Print this page
  • Print all pages

    • Programming Application in Specified address and Debug

    Posted by SLH on 2019-04-02 09:35

    Thanke you for answer.
    I did it, but the problem is that boot loader content changes and gets affected when the program is downloaded. Also, when debugging, this error is seen:

    No source available for "0x10100"

    and in Console i see:

    Error: Whole bank access must start at beginning of bank.
    Info : STM32L4xx flash size is 1024kb, base address is 0x8000000

    I think that base address must change to 0x8004000. But i don't know how to do.

    My Memory Section in .ld file is:

    MEMORY
    {
    FLASH (rx) : ORIGIN = 0x8004000, LENGTH = 496K
    RAM (xrw) : ORIGIN = 0x20000000, LENGTH = 96K
    RAM2 (xrw) : ORIGIN = 0x10000000, LENGTH = 32K
    }

    Reads: 2391
    Posted by dautrevaux on 2019-04-02 16:32 France

    Hi,

    Your problem was described, and solved, in several forum topics; for example look at http://www.openstm32.org/forumthread2364, the previous to last post explain how to avoid the bootloader to be erased when programming the application and may help you.

    Also do not forget to change the vector table offset as explained in the same post.

    For more information on this just do a search for "bootloader" in the forum.

    Bernard (Ac6)