System Workbench for STM32

Hey guys, super noob here,

I'm trying to interface with a NUCLEO - STM32L432KC board,

This is the console output whenever I try and run just an "empty" program from CUBEMX that builds without errors. The correct board is selected in setup.

Run Console Output:

Open On-Chip Debugger 0.10.0+dev-00021-g524e8c8 (2019-04-12-08:42)
Licensed under GNU GPL v2
For bug reports, read
http://openocd.org/doc/doxygen/bugs.html
none separate
Info : The selected transport took over low-level target control. The results might differ compared to plain JTAG/SWD
padded zone erase set to 1
adapter speed: 8000 kHz
adapter_nsrst_delay: 100
Info : clock speed 8000 kHz
in procedure 'program'
in procedure 'init' called at file "embedded:startup.tcl", line 495
in procedure 'ocd_bouncer'

• OpenOCD init failed **

shutdown command invoked

Debug Console Output:

Open On-Chip Debugger 0.10.0+dev-00021-g524e8c8 (2019-04-12-08:42)
Licensed under GNU GPL v2
For bug reports, read
http://openocd.org/doc/doxygen/bugs.html
none separate
Info : The selected transport took over low-level target control. The results might differ compared to plain JTAG/SWD
padded zone erase set to 1
adapter speed: 8000 kHz
adapter_nsrst_delay: 100
Info : Listening on port 6666 for tcl connections
Info : Listening on port 4444 for telnet connections
Info : clock speed 8000 kHz
in procedure 'init'
in procedure 'ocd_bouncer'

Debug Configurations

I attached a photo of what my debug configurations are, PLEASE HALP ME IM A NOOB 😑